Weathered Wood Shingles
Weathered wood shingles, Place the tip of a flat bar below the weathered piece of carpeting, and force the bar lower cladding tapping with a hammer. Pulling the flat bar to you will help loosen the coating degraded, and you can use your hands to remove only the lower part of the two horizontal halves created to cut your siding with the knife.
Put the two halves together revetment weathered wood shingles, and put on a new piece of lining to determine what size to cut your new section gradient coating. Using a knife, draw around the edge of the gradient coating, forming a hole in the large section of siding that will be cut. This large piece cut with a saw. You will have to apply a latex caulk to the right and left sides of the space where the paneling will again making sure filler gets on the edge of the backs of adjacent cladding parts.
Placing New Siding, Insert the new paneling part in the empty space weathered wood shingles, ensuring that at least one inch from the top edge of this part is below the coating adjacent piece above it. Key the bottom of the new piece of coating, the pin placement at an angle of approximately 3/4 inch from the bottom.