Planter Box with Trellis Design

Jul 26th

Planter box with trellis – Decorating your outdoor space with planters not have to cost a fortune. You can make your own box and add wheels to the bottom to move the pot without stressing your back. Adding a lattice wall at the back of the pot allows you to grow plants vine type of extra height in the garden space. Once you master the basic pattern, experiment with measures to adjust the size to your specific needs.

Wooden Planter Box with Trellis
Wooden Planter Box with Trellis

Build planter box with trellis, Measure then cut four square side panels to the planter: two must be 15 1/2 inches square and two 14 3/4 inches square. Cut the bottom Planter measuring 13 7/8 inches square. Measure and cut four pieces of wood to the top edge, which measures 17 inches by 3.4 inches by 1-1 / 2 inches. Cut four pieces of rim to hold the bottom of the planter: two with a measure 14 inches by 4.3 inches by 4.3 inches and two pieces measuring 12-1 / 2 inches by 4.3 inches by 3/4 inch. Fit the side panels and apply wood glue along the edges to hold them in place. Put the pieces together with two long screws 1 inch along each edge.

12 Photos Gallery of: Planter Box with Trellis Design

Image of: Large Planter Box with Trellis
Image of: New Planter Box with Trellis
Image of: Nice Planter Box with Trellis
Image of: White Planter Box with Trellis Design
Image of: Planter Box with Trellis Ideas
Image of: Planter Box with Trellis Picture
Image of: Planter Box with Trellis Style
Image of: Popular Planter Box with Trellis
Image of: Rustic Planter Box with Trellis
Image of: Top Planter Box with Trellis
Image of: White Planter Box with Trellis
Image of: Wooden Planter Box with Trellis
 

Paste the pieces of top finishes on the top of the sides so that there is no overlap on the inside edge. Place the piece of cornice with wood glue about 3/4 inches from inside the lower rim of the pot. holes drain hole five 1/4 evenly around the lower part planter box with trellis. Slide the bottom piece in the pot to rest on the lower rim. Screw one drive wheel at each bottom corner of the pot pitcher. Cut the lattice to a width of 14-1 / 2 inches and a height of 4 feet. Place the network on a panel inside the pot and attach with eight to 10 brad nails to hold it in place.

Leave a Reply