Build Arbor Swing with Trellis Top

Feb 24th

Arbor swing – Build upright assembly for arbor swing, Cut four 2-by-4 support posts 87 cm long piece. Cut two 2-by-4 connector pieces 15 cm long each. Place two 87-inch messages in parallel. Put 15 inch connector on the posts aligns the upper edge of the connector with the top of the posts. Make it flush with the outer edge of the messages. Drill holes through the two ends of the connectors and messages. Galvanizing and install bolts. Highlight the face of each footboard 16 ½ inches in from each end.

Top Arbor Swing
Top Arbor Swing

Arbor swing, Place a foot board flush with the bottom of the upright alignment of the uprights with the markings on the foot plate. The connector is inside the top of the uprights and the footboard on the bottom edge. Drill two holes through each post and foot board. Galvanizing and secure with carriage bolts. Install two brackets on each upright assembly with the angled cuts flush with the bottom of the foot board assembly and the inner edge of the uprights.

12 Photos Gallery of: Build Arbor Swing with Trellis Top

Image of: Arbor Swing Design
Image of: Arbor Swing Ideas
Image of: Arbor Swing Image
Image of: Arbor Swing Picture
Image of: Arbor Swing Style
Image of: Best Arbor Swing
Image of: New Arbor Swing
Image of: Original Arbor Swing
Image of: Popular Arbor Swing
Image of: Rustic Arbor Swing
Image of: Small Arbor Swing
Image of: Top Arbor Swing

Top Connectors for arbor swing, Cut two 87-inch long connectors from 2-by-6 inch boards. Cut an angle of 45 degrees at each end of the boards. Place the connectors on the front of the building with the top edges flush. Attached to the upright assembly with bolts. Countersink the screws. Repeat for the back of the assembly.Turn the assembly upright. Using a ladder to reach the top, center the third 87-inch connector between the two upper connectors. Tighten screws with the deck. Cut blocks of 2-by-4 boards to fit between turning the connectors and to prevent warping. Attach the blocks using wood screws.